HP 3000 Series Handbook

For HP Internal Use Only
Boot and System Initialization Failures
Table 5-9. Boot and System Initialization Failures
CAUSE/SYMPTOM
ACTION
11. Chassis code A008 displayed?
YES. IPL Boot Attempt. No boatable device found.
Attempt to boot from another device. If boot succeeds, replace
the boot device. If boot still fails, replace the Multifunction 1/0
card. If boot still fails, replace the CPU Card.
I
2. Chassis code 800x displayed
and IODC Error Status message
on console?
NO. Go to Step 2.
YES. ISL Boot Attempt. Do the following steps until the problem
is solved.
Check that the internal SCSI cable is terminated at both ends.
Replace
1/0 card for the device you attempted to boot from.
Replace
boot device attached to 1/0 card.
Replace
CPU Card.
Replace Multifunction 1/0 card.
I Refer to "Check 1/0 Card and Device LEDs" procedure.
Call Response Center. Refer to the "Calling the Response
Center" section for more information.
NO. Go to Step 3.
3a. Chassis code C5Fx displayed? YES. Primary path initialization failed. Reboot from alternate
path. If boot succeeds, replace the primary path disk device.
NO. Continue to Step 4b.
3b.
Chassis code C7Fx displayed? YES. Alternate or other path initialization failed. Reboot from
primary
path. If boot succeeds, replace the alternate path boot
device.
If boot fails from both primary and alternate boot path, replace
the Multifunction
1/0 card. If boot still fails, replace the CPU
Card.
NO. Go to Step 4.
Troubleshooting 5-13

HP 3000 Series Specifications

General

Brand	HP
Model	3000 Series
Category	Desktop
Language	English