For
HP
Internal Use Only
Dl:
Disconnect Remote Console
Definition:
This command causes
the
lAP
to
initiate
a modem disconnect sequence on
the
remote
support
modem
if
it
is being used as a remote console. After executing this command
the
lAP
de-asserts
the
modem control lines,
thus
forcing
the
modem
to
"hang
up"
the
telephone line.
The
remote
support
modem
port
is
then
no longer connected as a mirrored console,
and
the
local console
port
becomes master.
If
the
remote access mode (see
ER
command) was set
to
be single, remote
operator
access
is disabled
and
must
be re-enabled by using
the
ER
command
to
once again allow remote
operator
access.
If
the
remote access mode was set
to
be multiple,
the
lAP
will connect
the
next incoming call on
the
remote
support
modem
port
to
the
lAP
as a remote
operator
connection.
Valid From: Remote Modem
Port
DR:
Disable Remote Operator Access
Definition:
This
command
disables remote
operator
access on
the
support
modem
port.
If
an
operator
is
connected as a parallel console
at
the
time
this command is executed,
the
remote console is
disconnected. Any future incoming calls
to
the
remote
support
modem will be handled by
the
system as a user session.
If
remote
operator
access was already disabled when this command
is executed, this command has no effect.
If
background command processing for busy
ports
is
not
supported
on
the
l/0
card,
the
following applies:
When
switching from Remote
Operator
Enabled
to
Remote
Operator
Disabled, any buffered commands posted
to
the
host's remote modem
port
should be
completed
and
the
Estat
field
of
that
port's
lO_STATUS register set appropriately. This
indicates
to
the
driver
that
the
port
is no longer busy. A "ready
to
connect" connection
status
will be sent
to
the
driver.
Valid From: Local Console
Port,
Remote Modem
Port
OS:
Disable SPU Status Display
Definition:
Disable display
of
the
system's OSTAT
and
hex display
to
the
console terminals when
in
console mode. See ES: Enable
SPU
Status
Display command.
Valid From: Local Console
Port,
Remote Modem
Port
ER:
Enable Remote Operator Access
Definition:
This command, available only on
the
local console, enables remote console access
to
a user
on
the
modem
port
and
configures
the
connection security
parameters.
The
mode
parameter
establishes how
many
times
the
remote user may connect, disconnect,
and
reconnect
the
remote console before remote console access is automatically disabled.
The
password
parameter
is set by
the
local console
operator
and
stored in nonvolatile memory.
The
password fault
parameter
sets
the
number
of
password faults allowable (3 password
attempts
per fault) before remote console access is automatically disabled.
9-8 Functional Description
To Next Page
Loading...
Need help?
General