For
HP
Internal Use
Only
Stand-alone System Installation
1.
Unpack the system.
2.
Inspect for damage.
3. Move
the
equipment
to
where
it
will be used.
4.
Install any additional
I/0
PCAs.
5.
Install and configure any external peripherals.
Note
"
If
no SCSI peripherals are connected
to
the
Multifunction
I/0
PCA,
install
SCSI terminator, P
/N
1252-3932, on
the
SCSI connector.
6.
Cable everything
to
the
system. Refer
to
the system Installation and Configuration
manual for specific cabling instructions.
7.
Power up
the
external peripherals.
8.
Power up
the
system.
9.
At
the
ISL prompt, verify
the
I/0
hardware configuration with
MAPPER
in the Offline
Diagnostic Environment (ODE).
10. Boot
the
operating system.
11. Customize the system.
Rack System Installation
A-Series Rack Installation
1.
Unpack
the
system.
2.
Inspect for damage.
3.
Move
the
system
to
where
it
will be used.
4. Cable
the
LAN, if necessary.
5.
Connect power
to
the
rack.
6.
Power up
the
system.
7.
At
the
ISL
prompt,
verify the
I/0
hardware configuration with
MAPPER
in the Offline
Diagnostic Environment (ODE).
8.
Boot the operating system.
9.
Customize the system.
3-2 Installation and Preventive Maintenance
To Next Page
Loading...
Need help?
General