I VALUE
(HEX)
0
1
2
3
4
5
6
7
8
A
For
HP
Internal Use
Only
Table 5-54. Sense Key Codes
DESCRIPTION
NO SENSE. No specific Sense Key information to be reported, or the command executed
prior
to
the REQUEST SENSE command completed successf
RECOVERED ERROR. Last command completed successfully with some recovery action
performed by the logical unit.
NOT
READY. Logical unit cannot be accessed.
MEDIA ERROR. READ or
WRITE
command terminated with an error condition, or drive
encountered problems loading or unloading tape.
HARDWARE ERROR. Controller detected a hardware failure while executing a command
or performing a self-test.
ILLEGAL
REQUEST. Illegal parameter in the command descriptor block or in additional
parameters supplied as
data
for a command.
UNIT ATTENTION. Media has been exchanged, logical
unit
has been reset, or MODE
SELECT
parameters have been changed.
WRITE-PROTECTED.
Logical unit
attempted
to write on a write-protected tape.
BLANK
CHECK. Logical unit encountered End
Of
Data
(EOD).
COPY
ABORTED.
COPY
or
COPY
AND
VERIFY
command aborted due to an error
condition on the source device, destination device, or both.
B
ABORT COMMAND. Command was aborted.
5-70 Troubleshooting
To Next Page
Loading...
Need help?
General