For
HP
Internal Use
Only
C-Series Rack Installation
1.
Unpack
the
system.
2.
Inspect for damage.
3. Move
the
system
to
where
it
will
be
used.
4.
Install equipment
in
the
rack.
5.
Install any additional
I/0
PCAs.
6.
Install
and
configure any external peripherals.
7.
Connect power
to
all equipment.
8.
Connect power
to
the
rack.
9.
Power up
the
system.
10. At
the
ISL
prompt,
verify
the
I/0
hardware configuration with
MAPPER
in
the
Offline
Diagnostic Environment
(ODE).
11. Boot
the
operating
system.
12. Customize
the
system.
Preventive Maintenance
HP
A3024A
Smm
Tape Drive Maintenance
The
8mm
Tape Drive should be cleaned every 30 hours
of
tape
drive
operation
or
when
the
top
and
bottom
LEDs flash rapidly
and
the
middle LED flashes irregularly.
Table 1-14 shows
the
state
of
the
LEDs when
the
drive should be cleaned.
1. Insert
the
cleaning cartridge
into
the
drive.
2.
Cleaning begins automatically.
3.
When
cleaning is completed,
the
cartridge is
automatically
ejected.
4. After
the
drive has been successfully cleaned,
the
top
and
bottom
LEDs on
the
front panel
should no longer
be
flashing.
Note
•
Do
not
attempt
to
rewind
and
reuse
the
cleaning cartridge. Reusing
the
cleaning cartridge may reintroduce damaging debris
to
the
tape
drive head .
Installation and Preventive Maintenance 3-3
To Next Page
Loading...
Need help?
General