1
MCE configuration commands
NOTE:
• This chapter describes only the commands related to the MCE feature. For information about the
routing protocol configuration commands in the configuration examples, see
Layer 3—IP Routing
Command Reference
.
• The Layer 3 Ethernet interface in this document refers to an Ethernet port that can perform IP routing
and inter-VLAN routing. You can set an Ethernet port as a Layer 3 Ethernet interface by using the
port link-mode route command (see the
Layer 2—LAN Switching Command Reference
).
description
Description
Use the description command to configure a description for the current VPN instance.
Use the undo description command to delete the description.
Syntax
description text
undo description
View
VPN instance view
Default level
2: System level
Parameters
text: Describes the VPN instance, which is a string of 1 to 80 characters.
Examples
# Configure a description for VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] description vpn1
display bgp vpnv4 vpn-instance group
Description
Use the display bgp vpnv4 vpn-instance group command to display information about a specific BGP
VPNv4 peer group or all BGP VPNv4 peer groups.
Syntax
display bgp vpnv4 vpn-instance vpn-instance-name group [ group-name ] [ | { begin | exclude | include }
regular-expression ]
To Next Page
Loading...
Need help?
General
