HP 5800 Series User Manual

343
undo tunnel select-seq
View
Tunneling policy view
Default level
2: System level
Parameters
cr-lsp: Specifies CR-LSP tunnels.
lsp: Specifies LSP tunnels.
load-balance-number number: Specifies the number of tunnels for load balancing. The number parameter
is ranging from 1 to 8.
Examples
# Define a tunneling policy, specifying that only LSP tunnels are used and the number of tunnels for load
balancing be 2.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1] tunnel select-seq lsp load-balance-number 2
vpn-target (VPN instance view)
Description
Use the vpn-target command to configure VPN targets for a VPN instance.
Use the undo vpn-target command to remove the specified or all VPN targets of a VPN instance.
By default, no VPN targets are configured for a VPN instance. You must configure VPN targets when
creating a VPN instance.
• VPN targets configured in VPN instance view is applicable to both the IPv4 VPN and the IPv6 VPN.
• VPN targets configured in IPv4 VPN view is applicable to only the IPv4 VPN.
• VPN targets configured in IPv4 VPN view takes precedence over that configured in VPN instance
view. If you configure VPN targets in both IPv4 VPN view and VPN instance view, those configured
in IPv4 VPN view are applied to the IPv4 VPN.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
View
VPN instance view, IPv4 VPN view
Default level
2: System level
Parameters
vpn-target&<1-8>: Adds VPN target extended community attributes to the import VPN target extended
community attribute list (Import Target) or export VPN target extended community attribute list (Export
Target). &<1-8> means that you can add up to eight VPN targets.

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English