98
Related commands: remote-ip.
Syntax
mpls ldp remote-peer remote-peer-name
undo mpls ldp remote-peer remote-peer-name
View
System view
Default level
2: System level
Parameters
remote-peer-name: Specifies the name of the remote peer, which is a case-insensitive string of 1 to 32
characters.
Examples
# Create a remote peer entity named BJI, and enter MPLS LDP remote peer view.
<Sysname> system-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji]
mpls ldp timer hello-hold
Description
Use the mpls ldp timer hello-hold command to set a hello timer.
Use the undo mpls ldp timer hello-hold command to restore the default.
In interface view, you set the link hello timer. In MPLS LDP remote peer view, you set the targeted hello
timer.
By default, the value of the link hello timer is 15 seconds, and that of the targeted hello timer is 45
seconds.
Changing the values of the hello timers does not affect any existing session.
Related commands: mpls ldp (interface view) and mpls ldp (system view).
Syntax
mpls ldp timer hello-hold value
undo mpls ldp timer hello-hold
View
Interface view, MPLS LDP remote peer view
Default level
2: System level
Parameters
value: Specifies the value of the hello timer, ranging from 1 to 65,535, in seconds.
Examples
# Set the link hello timer to 100 seconds on interface VLAN-interface 1.
To Next Page
Loading...
Need help?
General
