102
Parameters
lsr-id: Specifies the ID for identifying the LSR, in dotted decimal notation.
Examples
# Set the LSR ID to 3.3.3.3.
<Sysname> system-view
[Sysname] mpls lsr-id 3.3.3.3
path-vectors
Description
Use the path-vectors command to specify the path vector length.
Use the undo path-vectors command to restore the default.
By default, the path vector length is 32. That is, the number of LSR IDs in a path vector cannot exceed 32.
This command must be configured before you enable LDP on any interface.
Related commands: loop-detect and hops-count.
Syntax
path-vectors pv-number
undo path-vectors
View
MPLS LDP view, MPLS LDP VPN instance view
Default level
2: System level
Parameters
pv-number: Specifies the path vector length, ranging from 1 to 32.
Examples
# Set the maximum hops of the path vector to 3 for the public network LDP instance.
<Sysname> system-view
[Sysname] mpls ldp
[Sysname-mpls-ldp] path-vectors 3
# Set the maximum hops of the path vector to 3 for LDP instance vpn1.
<Sysname> system-view
[Sysname] mpls ldp vpn-instance vpn1
[Sysname-mpls-ldp-vpn-instance-vpn1] path-vectors 3
periodic-tracert
Description
Use the periodic-tracert command to enable periodic LSP tracert for a FEC.
Use the undo periodic-tracert command to disable periodic LSP tracert for a FEC.
By default, the periodic LSP tracert for a FEC is not enabled.
To Next Page
Loading...
Need help?
General
