HP 5800 Series User Manual

95
Syntax
md5-password { cipher | plain } peer-lsr-id password
undo md5-password peer-lsr-id
View
MPLS LDP view, MPLS LDP VPN instance view
Default level
2: System level
Parameters
cipher: Displays the password in cipher text.
plain: Displays the password in plain text.
peer-lsr-id: Specifies the MPLS LSR ID of the peer.
password: Specifies the password string, case sensitive. If you specify the plain keyword, it must be a
string of 1 to 16 characters in plain text. If you specify the cipher keyword, it can be either a string of 1 to
16 characters in plain text or a string of 24 characters in cipher text.
Examples
# Enable MD5 authentication for the public network LDP instance, configuring the password used for the
MD5 authentication with peer 3.3.3.3 as pass and setting the password display mode as plain text.
<Sysname> system-view
[Sysname] mpls ldp
[Sysname-mpls-ldp] md5-password plain 3.3.3.3 pass
# Enable MD5 authentication for LDP instance vpn1, configuring the password used for the MD5
authentication with peer 3.3.3.3 as pass and setting the password display mode as plain text.
<Sysname> system-view
[Sysname] mpls ldp vpn-instance vpn1
[Sysname-mpls-ldp-vpn-instance-vpn1] md5-password plain 3.3.3.3 pass
mpls
Description
Use the mpls command in system view to enable MPLS globally and enter MPLS view.
Use the undo mpls command in system view to disable MPLS globally.
Use the mpls command in interface view to enable MPLS for the interface.
Use the undo mpls command in interface view to disable MPLS for the interface.
By default, MPLS capability is disabled globally and on all interfaces.
Related commands: mpls lsr-id.
You should configure the MPLS LSR ID before enabling MPLS capability. Also, you should enable MPLS
globally before enabling it for an interface.
Syntax
mpls
undo mpls

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English