127
Field Description
Authentication State of authentication: enabled or disabled.
Reliability Whether the reliability feature is configured: yes or no.
Retransmit interval Initial retransmission interval (in milliseconds).
Increment value
Increment value delta that governs the speed at which the interface
increases the retransmission interval.
Assume the initial interval is Rf seconds. If the interface does not
receive an ACK message for a packet within this interval, it
retransmits the packet after (1 + Increment value) × Rf seconds.
display mpls rsvp-te established
Description
Use the display mpls rsvp-te established command to display information about RSVP-TE tunnels.
Syntax
display mpls rsvp-te established [ interface interface-type interface-number ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do not
specify an interface, the command displays the RSVP-TE tunnel information of all interfaces.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 80 characters.
Examples
# Display RSVP-TE tunnel information for interface VLAN-interface 3.
<Sysname> display mpls rsvp-te established interface vlan-interface 3
Interface Vlan-interface3
Token Bucket Rate: 0.00 Peak Data Rate: 0.00
Tunnel Dest: 2.2.2.2 Ingress LSR ID: 3.3.3.3
Local LSP ID: 4 Session Tunnel ID: 4
Next Hop Addr: 80.4.1.1
Upstream Label: 1024 Downstream Label: 3
To Next Page
Loading...
Need help?
General
