HP 5800 Series User Manual

101
mpls lspv
Description
Use the mpls lspv command to enable the LSP verification function and enter MPLS LSPV view.
Use the undo mpls lspv command to disable the LSP verification function.
By default, LSP verification is disabled.
Syntax
mpls lspv
undo mpls lspv
View
System view
Default level
2: System level
Parameters
None
Examples
# Enable LSP verification and enter MPLS LSPV view.
<Sysname> system-view
[Sysname] mpls lspv
[Sysname-mpls-lspv]
mpls lsr-id
Description
Use the mpls lsr-id command to configure the ID of an LSR.
Use the undo mpls lsr-id command to remove the ID of an LSR.
By default, no LSR ID is configured.
Configure the LSR ID of an LSR before configuring any other MPLS commands.
HP recommends that you use the address of a loopback interface on the LSR as the ID.
Related commands: display mpls interface.
Syntax
mpls lsr-id lsr-id
undo mpls lsr-id
View
System view
Default level
2: System level

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English