17
Field Description
Threshold Value(%)
Maximum ratio of the actual route number to the maximum route
number in percentage. When the ratio is reached, the device
rejects new routes.
Interfaces Interface to which the VPN instance is bound.
domain-id
Description
Use the domain-id command to configure an OSPF domain ID.
Use the undo domain-id command to restore the default.
By default, the OSPF domain ID is 0.
With no parameter specified, the undo domain-id command deletes the primary domain ID.
Usually, routes injected from PEs are advertised as External-LSAs. However, routes to different destinations
in the same OSPF domain must be advertised as Type-3 LSAs. Therefore, using the same domain ID is
required for an OSPF domain.
Syntax
domain-id domain-id [ secondary ]
undo domain-id [ domain-id ]
View
OSPF view
Default level
2: System level
Parameters
domain-id: Specifies the OSPF domain ID, which can be in one of the following formats:
• Integer, ranging from 0 to 4,294,967,295. For example, 1.
• Dotted decimal notation. For example, 0.0.0.1.
• Dotted decimal notation:16-bit user-defined number, ranging from 0 to 65,535. For example,
0.0.0.1:512.
secondary: Uses the domain ID as secondary. With this keyword not specified, the domain ID configured
is primary.
Examples
# Configure the OSPF domain ID.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpn1
[Sysname-ospf-100] domain-id 234
To Next Page
Loading...
Need help?
General
