196
Default level
2: System level
Parameters
tunnel-name: Specifies the tunnel name, which is a case-sensitive string of 1 to 15 characters. It must be
an exact reference to a tunnel interface created by the interface tunnel command. For example, if the
tunnel interface created is Tunnel2, the tunnel name referenced here must be Tunnel2.
destination dest-addr: Specifies the IP address of the tunnel destination.
nexthop next-hop-addr: Specifies the next hop address.
out-label out-label-value: Specifies the outgoing label, which can be a value of 0, 3, or 16 through 1023.
Examples
# Configure a static CR-LSP on the ingress node, setting its name to Tunnel3, destination IP address to
202.25.38.1, destination address mask length to 24, next hop IP address to 202.55.25.33, outgoing
label to 237, CT of traffic to CT 0, and required bandwidth to 20 kbps.
<Sysname> system-view
[Sysname] static-cr-lsp ingress Tunnel3 destination 202.25.38.1 nexthop 202.55.25.33 out-
label 237 bandwidth ct0 20
static-cr-lsp transit
Description
Use the static-cr-lsp transit command to configure a static CR-LSP on a transit node.
Use the undo static-cr-lsp transit command to remove the static CR-LSP.
The next hop address cannot be a local public address when configuring the static CR-LSP on the ingress
or a transit node.
Syntax
static-cr-lsp transit tunnel-name incoming-interface interface-type interface-number in-label in-label-value
{ nexthop next-hop-addr | outgoing-interface interface-type interface-number } out-label out-label-value
undo static-cr-lsp transit tunnel-name
View
System view
Default level
2: System level
Parameters
tunnel-name: Specifies the tunnel name, which is a string of 1 to 15 characters.
incoming-interface interface-type interface-number: Specifies an incoming interface for the static CR-LSP.
in-label in-label-value: Specifies the incoming label, which ranges from 16 to 1023.
nexthop next-hop-addr: Specifies the next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing interface for the static CR-LSP.
This keyword and parameter combination is supported depending on your device.
out-label out-label-value: Specifies the outgoing label, which can be a value of 0, 3, or16 through 1023.
To Next Page
Loading...
Need help?
General
