174
Examples
# Enable BFD for the MPLS TE tunnel on tunnel interface Tunnel1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] mpls te bfd enable
mpls te commit
Description
Use the mpls te commit command to submit current MPLS TE tunnel configuration.
The MPLS TE tunnel configuration you made can take effect only after you perform this command.
Syntax
mpls te commit
View
Tunnel interface view
Default level
2: System level
Parameters
None
Examples
# Configure an MPLS TE tunnel and submit the configuration.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] tunnel-protocol mpls te
[Sysname-Tunnel0] destination 2.2.2.9
[Sysname-Tunnel0] mpls te commit
mpls te cspf
Description
Use the mpls te cspf command to enable CSPF on current node.
Use the undo mpls te cspf command to disable CSPF on current node.
By default, CSPF is disabled on current node.
Before enabling CSPF, enable MPLS TE in MPLS view.
CSPF provides an approach to path selection in MPLS domains. You must enable CSPF before configuring
other CSPF-related functions.
Syntax
mpls te cspf
undo mpls te cspf
View
MPLS view
To Next Page
Loading...
Need help?
General
