HP 5800 Series User Manual

197
Examples
# Configure a static CR-LSP on the transit node, setting its name to tunnel34, incoming interface to VLAN-
interface 3, incoming label to 123, outgoing interface to VLAN-interface 4, outgoing label to 253.
<Sysname> system-view
[Sysname] static-cr-lsp transit tunnel34 incoming-interface Vlan-interface 3 in-label 123
outgoing-interface Vlan-interface 4 out-label 253
tracert lsp te
Description
Use the tracert lsp te command to locate errors of MPLS TE tunnels.
Syntax
tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode |-t time-out ] * te interface-type
interface-number
View
Any view
Default level
0: Visit level
Parameters
-a source-ip: Specifies the source IP address of the Echo Request messages.
-exp exp-value: Specifies the EXP value for the Echo Request messages. The exp-value parameter ranges
from 0 to 7 and defaults to 0.
-h ttl-value: Specifies the TTL value for the Echo Request messages. The ttl-value parameter ranges from 1
to 255 and defaults to 30.
-r reply-mode: Specifies the reply mode of the receiver in response to an Echo Request message. The
reply-mode parameter can be 1 or 2, where 1 means “Do not respond” and 2 means “Respond using a
UDP packet.” The default is 2.
-t time-out: Specifies the timeout interval for waiting for the response to an echo request message. The
time-out parameter ranges from 0 to 65,535 and defaults to 2000, in milliseconds.
te interface-type interface-number: Specifies a tunnel interface.
Examples
# Tracert the MPLS TE tunnel of tunnel interface Tunnel 1.
<Sysname> tracert lsp te tunnel 1
LSP Trace Route FEC: TE TUNNEL IPV4 SESSION QUERY Tunnel1 , press CTRL_C to break.
TTL Replier Time Type Downstream
0 Ingress 10.4.5.1/[1025]
1 10.4.5.1 1 Transit 100.3.4.1/[1024]
2 100.3.4.1 63 Transit 100.1.2.1/[3]
3 100.1.2.1 129 Egress

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English