131
Field Description
Ingress LSR ID Ingress LSR ID, in the format of X.X.X.X.
Local LSP ID Local LSP ID.
Next Hop Next hop address, in the format of X.X.X.X.
Previous Hop Previous hop address, in the format of X.X.X.X.
In Label Incoming label.
Out Label Outgoing label.
Send message ID Instance of sent Message ID.
Resv Message ID Instance of received Message ID.
Setup Prio Session setup priority.
HoldPrio Session hold priority.
Session Flag Session flag (local protection policy, label, SE style).
ERO Information Information about explicit routes.
L-Type Explicit routing type: strict or loose.
ERO-IPAddress IP address for an explicit route.
ERO-Prefix Len Prefix length for an explicit route.
RRO Information Information about route recording.
RRO-C Type Type of route recording.
RRO-IP Address IP address of recorded route in the format of X.X.X.X.
RRO-IPPrefixLen IP prefix length of recorded route.
Sender Tspec Information Information about sender's service specifications.
Token Bucket rate Token bucket rate (in kbps), a traffic parameter.
Token Bucket size Token bucket size, a traffic parameter.
Peak Data Rate Peak data rate (in kbps), a traffic parameter.
Maximum packet size Maximum packet size, a traffic parameter.
Minimum policed unit Minimum policed unit, a traffic parameter.
Path message Path message sent from the interface to the next hop at X.X.X.X.
Resource Available when the RSVP flag is configured.
Graceful Restart State
State of GR: stale or normal. Displayed as --- when not supported by
the device.
display mpls rsvp-te request
Description
Use the display mpls rsvp-te request command to display information about RSVP-TE requests on the
specified or all interfaces.
To Next Page
Loading...
Need help?
General
