HP 5800 Series User Manual

28
View
VPN instance view
Default level
2: System level
Parameters
route-distinguisher: Specifies the RD for the VPN instance, which is a string of 3 to 21 characters in one of
the following three formats:
• 16 - b i t AS n u m b e r :32-bit user-defined number. For example, 101:3.
• 32-bit IP address:16-bit user-defined number. For example, 192.168.122.15:1.
• 32-bit AS number:16-bit user-defined number, where the minimum value of the AS number is 65,536.
For example, 65536:1.
Examples
# Configure the RD of VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 22:1
routing-table limit
Description
Use the routing-table limit command to limit the maximum number of routes in a VPN instance,
preventing too many routes from being accepted by a PE.
Use the undo routing-table limit command to restore the default.
The default maximum number of routes that a VPN instance supports varies by device.
• A limit configured in IPv4 VPN view is applicable to only the IPv4 VPN.
• A limit configured in IPv4 VPN view takes precedence over that configured in VPN instance view. If
you configure a limit in both IPv4 VPN view and VPN instance view, the limit configured in IPv4
VPN view is applied to the IPv4 VPN.
Syntax
routing-table limit number { warn-threshold | simply-alert }
undo routing-table limit
View
VPN instance view, IPv4 VPN view
Default level
2: System level
Parameters
number: Specifies the maximum number of routes for the VPN instance to support. The value ranges from
1 to 8192.
warn-threshold: Specifies a threshold for warning, ranging from 1 to 100, in percentages. When the
percentage of the number of existing routes to the maximum number of routes supported exceeds the

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English