331
Syntax
reflect between-clients
undo reflect between-clients
View
BGP-VPNv4 subaddress family view, BGP-L2VPN address family view, VPLS address family view
Default level
2: System level
Parameters
None
Examples
# In BGP-VPNv4 subaddress family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpnv4
[Sysname-bgp-af-vpnv4] undo reflect between-clients
# In BGP-L2VPN address family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] l2vpn-family
[Sysname-bgp-af-l2vpn] undo reflect between-clients
# In VPLS address family view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] vpls-family
[Sysname-bgp-af-vpls] undo reflect between-clients
reflector cluster-id
Description
Use the reflector cluster-id command to specify a cluster ID for an RR.
Use the undo reflector cluster-id command to remove the cluster ID.
By default, the cluster ID is the router ID of an RR in the cluster.
Generally, a cluster contains only one RR, in which case the router ID of the RR is used for identifying the
cluster. Setting multiple RRs can improve the network reliability. When more than one RR exists in a cluster,
use the reflector cluster-id command to configure the same cluster ID for all RRs in the cluster.
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
View
BGP-VPNv4 subaddress family view, BGP-L2VPN address family view, VPLS address family view
To Next Page
Loading...
Need help?
General
