Step 2 Run:
ospfv3 [ process-id ]
OSPFv3 is enabled and the OSPFv3 view is displayed.
Step 3 Run:
router-id router-id
A Router ID is set.
----End
5.3.3 Enabling OSPFv3 on an Interface
For an interface with multiple instances, you need to specify which instance of the interface is
enabled in the OSPFv3 process when enabling OSPFv3 on the interface.
Context
After enabling OSPFv3 in the system view, you need to enable OSPFv3 on the interface.
Because an interface has multiple instances, you need to specify which instance of the interface
is enabled in the OSPFv3 process when OSPFv3 is enabled on the interface. If no instance ID
is specified, the value defaults to 0. The same instance must be enabled on the interfaces between
which the neighbor relationship is set up.
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
ospfv3 process-id area area-id [ instance instance-id ]
OSPFv3 is enabled on the VLANIF interface.
The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4
address format.
Step 4 (Optional) Run the ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] |
p2p } [ instance instance-id ] command to configure the network type of an interface.
When an interface supports multi-instances, you must specify the value of instance-id when
enabling OSPFv3 on the interface. If the value of instance-id is not specified, the default value
0 is adopted. In this case, the configured network type of an interface mismatches the actual
network type of the interface. This step is mandatory in such a case.
----End
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
189
To Next Page
Loading...
Need help?
General
