When an MBGP fault occurs, run the following debugging commands in the user view to debug
MBGP and locate the fault.
For more information about debugging commands, refer to the S6700 Series Ethernet Switches
Debugging Reference.
Procedure
l Run the debugging bgp all command in the user view to enable all the debugging of MBGP.
l Run the debugging bgp event command in the user view to enable the debugging of MBGP
event.
l Run the debugging bgp { keepalive | open | packet | route-refresh } [ receive | send ]
[ verbose ] command in the user view to enable the debugging of MBGP packets.
l Run the debugging bgp update multicast [ acl acl-number | ip-prefix ip-prefix-name |
peer peer-address ] [ receive | send ] [ verbose ] command in the user view to enable the
debugging of MBGP update packets.
----End
9.9 Configuration Examples
MBGP configuration examples are provided, including networking requirements and diagram,
configuration roadmap, and configuration notes.
9.9.1 Example for Configuring Basic MBGP Functions
Networking Requirements
As shown in Figure 9-1, the receiver receives VOD information in multicast mode. The receiver
and the source reside in different ASs. The MBGP peer relationship is established between ASs
to transmit multicast routing information.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 9 MBGP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
582
To Next Page
Loading...
Need help?
General
