EasyManuals Logo

Huawei S6700 Series Configuration Guide

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #320 background imageLoading...
Page #320 background image
– Configure IS-IS to advertise a default route.
This mode is easy to configure and does not require devices in IS-IS areas to learn
external routes. After a default route is advertised, all traffic in an IS-IS area is forwarded
through the default route.
– Configure IS-IS to import external routes.
This mode enables all devices in IS-IS areas to learn external routes, implementing
refined control over traffic forwarding.
To ensure successful forwarding of traffic destined for IS-IS areas, you must also enable
the other routing protocols to interact with IS-IS.
Pre-configuration Tasks
Before configuring IPv6 IS-IS to interact with other routing protocols, complete the following
tasks:
l Configuring the link layer protocol on interfaces
l Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at
the network layer
l Configuring Basic IPv6 IS-IS Functions
l Configuring basic functions of other routing protocols
Data Preparation
To configure the IPv6 IS-IS to interact with other routing protocols, you need the following data.
No.
Data
1 ACL6 for filtering routes, IPv6 prefix list, or routing policy
2 Preference value of IS-IS
6.14.2 Configuring a Preference Value for IPv6 IS-IS
If multiple routes to the same destination are discovered by different routing protocols,
configuring the highest preference value for IS-IS allows a route discovered by IS-IS to be
selected preferentially.
Context
If multiple routes to the same destination are discovered by different routing protocols running
on the same device, the route discovered by the protocol with the highest preference is selected.
For example, if both OSPFv3 and IS-IS are configured on a network, the route discovered by
OSPFv3 is used because OSPFv3 has a higher preference than IS-IS by default.
To prefer a route discovered by IS-IS, configure a higher preference value for IS-IS. In addition,
a routing policy can be configured to increase the preferences of specified IS-IS routes, without
affecting route selection.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
301

Table of Contents

Other manuals for Huawei S6700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S6700 Series and is the answer not in the manual?

Huawei S6700 Series Specifications

General IconGeneral
BrandHuawei
ModelS6700 Series
CategorySwitch
LanguageEnglish

Related product manuals