The OSPFv3 view is displayed.
Step 3 Run:
area area-id
The OSPFv3 area view is displayed.
Step 4 Run:
vlink-peer router-id [ hello hello-interval | retransmit retransmit-interval |
trans-delay trans-delay-interval | dead dead-interval | instance instance-id ]
*
A virtual link is created and configured.
----End
5.5.4 Checking the Configuration
After OSPFv3 area attributes are configured, you can check the OSPFv3 LSDB, routing table,
and virtual links.
Prerequisites
The configurations for the OSPFv3 Areas are complete.
Procedure
l Run the commands as follow to check the LSDB information about OSPFv3:
– display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-
router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-
router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix |
grace } [ link-state-id ] ]
– display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-
originate ] external [ ipv6-address prefix-length ] [ link-state-id ]
l Run the commands as follow to check the OSPFv3 routing table:
– display ospfv3 [ process-id ] routing uninstalled
– display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics
[ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes |
nssa-routes ]
l Run the display ospfv3 [ process-id ] vlink command to check the information about
OSPFv3 virtual links.
----End
5.6 Configuring OSPFv3 NSSA Areas
By configuring areas as NSSA areas, external routes can be imported, and a new type of LSA,
namely, Type 7 NSSA LSA is introduced.
5.6.1 Establishing the Configuration Task
NSSAs are introduced because stub areas cannot import external routes. An NSSA allows the
transmission of Type 7 LSAs.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
197
To Next Page
Loading...
Need help?
General
