processing the changes. Instead, the RM waits for a certain period, and then notifies various
protocols of applying the changed routing policy.
l If the routing policy changes again during the waiting time, the RM resets the timer.
You can run related commands to set the waiting time as required.
Pre-configuration Tasks
None.
Data Preparation
To configure the valid time of the routing policy, you need the following data.
No. Data
1 Delay for applying the routing policy
10.8.2 Configuring the Delay for Applying the Routing Policy
When modifying multiple cooperative routing policies, you need to configure the delay for
applying a routing policy.
Context
Do as follows on the switch on which the delay for applying routing policy needs to be changed:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
route-policy-change notify-delay delay-time
The delay for applying the routing policy is set.
The delay ranges from 1 to 180, in seconds.
By default, the RM immediately notifies the protocol of applying the new policy when the routing
policy changes.
Step 3 Run:
quit
Back to the user view.
Step 4 (Optional) Run:
refresh bgp all { export | import }
BGP is configured to apply the new routing policy.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 10 Routing Policy Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
615
To Next Page
Loading...
Need help?
General
