Applicable Environment
To meet the requirements of a complex network, you need to control the advertising of RIPng
routing information accurately. After performing configuration procedures in this section, you
can:
l Advertise default routes to neighbors.
l Suppress interfaces from sending RIPng Update packets.
l Import external routes from various routing protocols and filter routes to be advertised.
Pre-configuration Tasks
Before configuring the switch to control the advertising of RIPng routing information, complete
the following tasks:
l Configuring IPv6 addresses for interfaces to ensure that neighboring nodes are reachable
at the network layer
l 2.3 Configuring Basic RIP Functions
Data Preparation
To control the advertising of RIPng routing information, you need the following data.
No.
Data
1 Metric of the default route to be advertised
2 Protocol name and process ID of the external route to be imported
3.5.2 Configuring RIPng Route Summarization
By configuring a RIPng router to advertise the summarized IPv6 address on an interface, you
can save the space used by RIPng routes in the routing table. You can also set parameters to
prevent an interface from learning the same summarized route.
Context
This configuration is to configure the RIPng switch to advertise the summarized IPv6 prefix
rather than specific routes on an interface.
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
67
To Next Page
Loading...
Need help?
General
