Procedure
Step 1 Run the display isis name-table [ process-id | vpn-instance vpn-instance-name ] command to
check the mapping from the name of the local device to the system ID.
Step 2 Run the display isis peer [ verbose ] [ process-id | vpn-instance vpn-instance-name ] command
to check information about IS-IS neighbors.
Step 3 Run the display isis interface [ verbose ] [ process-id | vpn-instance vpn-instance-name ]
command to check information about IS-IS interfaces.
Step 4 Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ] [ verbose |
[ level-1 | level-2 ] | ip-address [ mask | mask-length ] ]
*
command to check information about
IS-IS routes.
----End
6.4 Establishing or Maintaining IS-IS Neighbor
Relationships or Adjacencies
This section describes how to configure the parameters that affect the IS-IS neighbor
relationship.
6.4.1 Establishing the Configuration Task
Before configuring the parameters that affect the IS-IS neighbor relationship, familiarize
yourself with the applicable environment, complete the pre-configuration tasks, and obtain the
required data. This can help you complete the configuration task quickly and accurately.
Applicable Environment
This section describes how to establish or maintain the IS-IS neighbor relationship, covering:
l Adjusting timers of various IS-IS packets, including Hello packets, CSNPs, and LSPs
l Adjusting parameters of LSPs
Pre-configuration Tasks
Before establishing or maintaining IS-IS neighbor relationships or adjacencies, complete the
following tasks:
l Configuring IP addresses of interfaces to make neighboring nodes reachable
l 6.3 Configuring Basic IPv4 IS-IS Functions
Data Preparation
To establish or maintain IS-IS neighbor relationships or adjacencies, you need the following
data.
No.
Data
1 Parameters of IS-IS timers
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
253
To Next Page
Loading...
Need help?
General
