The source address check is configured for RIP Update packets.
When receiving a packet, RIP checks the source address of the packet. If the packet
fails in the check, it is not processed.
By default, the source address check is enabled.
----End
2.8.6 Configuring RIP Neighbors
Generally, RIP sends packets by using broadcast or multicast addresses. To run RIP on the links
that do not support the forwarding of broadcast or multicast packets, you need to specify RIP
neighbors.
Context
Generally, RIP sends packets by using broadcast or multicast addresses. If RIP needs to run on
the links that do not support the forwarding of broadcast or multicast packets, you need to
configure the devices at both ends of the link as each other's neighbor.
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
Step 3 Run:
peer ip-address
The RIP neighbor is configured.
----End
2.8.7 Checking the Configuration
After the function of adjusting and optimizing the RIP network performance is successfully
configured, you can view the current running status, routing information, neighbor information,
and interface information of RIP.
Prerequisites
The configurations of optimizing a RIP network are complete.
Procedure
l Run the display rip [ process-id | vpn-instance vpn-instance-name ] command to check
the running status and configuration of RIP.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
47
To Next Page
Loading...
Need help?
General
