NOTE
Do not set a value which is too small, for the interval between LSA retransmissions. Otherwise, unnecessary
retransmissions may occur.
----End
5.4.5 Configuring the Delay for Transmitting LSAs on the Interface
It takes time to transmit OSPFv3 packets on a link. Therefore, a certain delay is added to the
aging time of an LSA before the LSA is sent.
Context
The LSA ages out in the LSDB of a local switch instead of in the transmission process. You
need to set the delay for an LSA before sending it. For a low-speed network, this configuration
is necessary.
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 trans-delay interval [ instance instance-id ]
The delay in transmitting LSAs on the interface is set.
----End
5.4.6 Checking the Configuration
After OSPFv3 neighbor relationships or adjacencies are stable, you can check OSPFv3 interface
information and neighbor information.
Prerequisites
The configurations for the Establishing or Maintaining OSPFv3 Neighbor Relationship are
complete.
Procedure
l Run the display ospfv3 interface [ area area-id ] [ interface-type interface-number ]
command to check the OSPFv3 interface information.
----End
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
194
To Next Page
Loading...
Need help?
General
