l Whether MBGP advertises all local routes or only the locally aggregated routes
l Whether MBGP advertises default routes
l Whether MBGP advertises community attributes or extended community attributes
l Whether a BGP Update message sent by an MBGP peer carries the private AS number
Pre-configuration Tasks
Before configuring the policy for advertising MBGP routes, complete the task of Configuring
Basic MBGP Functions.
Data Preparation
To configure the policy for advertising MBGP routes, you need the following data.
No. Data
1 AS number
2 Address of a remote peer or the name of a peer group
3 Name of the routing policy
4 Addresses and masks of the local routes that need to be aggregated
9.4.2 (Optional) Configuring the Next Hop of a Route as the Local
Address
Configuring the next-hop of a route as the local address is applicable to IBGP peers.
Context
Do as follows on the switch configured with an MBGP peer.
NOTE
The configuration is optional, and is valid only for IBGP peer or peer group.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
ipv4-family multicast
The BGP-IPv4 multicast address family view is displayed.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 9 MBGP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
561
To Next Page
Loading...
Need help?
General
