EasyManuals Logo

Huawei S6700 Series Configuration Guide

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #658 background imageLoading...
Page #658 background image
NOTE
In this step, you must specify vpn-instance vpn-instance-name.
Step 3 (Optional) Run the import-route { limt limt-number | protocol [ process-id ] [ cost cost | route-
policy route-policy-name |tag tag | type type ]
*
} command to import routes from other routing
protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
Step 4 Run the area { area-id | area-id-address } command to create an OSPF area and enter the OSPF
area view.
Step 5 Run the network ip-address wildcard-mask command to enable OSPF routes on the network
segment where the IP address of the VLANIF interface bound to the VPN instance belongs.
----End
11.5.5 (Optional) Configuring IS-IS Between an MCE and a PE
Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the interface vlanif vlan-id command to enter the view of the VLANIF interface bound to
the VPN instance.
Step 3 Run the isis enable [ process-id ] command to enable IS-IS on the VLANIF interface.
By default, IS-IS is disabled on a VLANIF interface.
Step 4 Run the isis [ process-id ] vpn-instance vpn-instance-name command to create an IS-IS process
used by a VPN instance and enter the IS-IS view.
Step 5 Run the network-entity net command to configure a NET.
By default, no NET is configured for an IS-IS process.
Step 6 (Optional) Run the import-route protocol [ process-id ] [ cost-type { external | internal } |
cost cost | tag tag | route-policy route-policy-name | [ level-1 | level-2 | level-1-2 ] ]
*
command
to import routes from other routing protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
----End
11.5.6 (Optional) Configuring BGP Between an MCE and a PE
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 11 MCE Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
639

Table of Contents

Other manuals for Huawei S6700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S6700 Series and is the answer not in the manual?

Huawei S6700 Series Specifications

General IconGeneral
BrandHuawei
ModelS6700 Series
CategorySwitch
LanguageEnglish

Related product manuals