Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospfv3 [ process-id ]
The OSPFv3 view is displayed.
Step 3 Run:
maximum load-balancing number
The maximum number of equal-cost routes is set.
The value is an integer ranging from 1 to 3. The default value is .
----End
5.7.4 Checking the Configuration
After OSPFv3 route attributes are configured, you can check the OSPFv3 interface, LSDB, and
routing table.
Prerequisites
The configurations for the OSPFv3 Route Attributes are complete.
Procedure
l Run the display ospfv3 interface [ area area-id ] [ interface-type interface-number ]
command to check the OSPFv3 interface information.
l Run the commands as follow to check the LSDB information about OSPFv3:
– display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-
router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-
router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix |
grace } [ link-state-id ] ]
– display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-
originate ] external [ ipv6-address prefix-length ] [ link-state-id ]
l Run the commands as follow to check the OSPFv3 routing table:
– display ospfv3 [ process-id ] routing uninstalled
– display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics
[ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes |
nssa-routes ]
----End
5.8 Controlling OSPFv3 Routing Information
This section describes how to control OSPF routing information. Detailed operations include
configuring route aggregation, filtering the received routes, and importing external routes.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
201
To Next Page
Loading...
Need help?
General
