l Configuring Basic BGP4+ Functions
Data Preparation
To configure a BGP4+ peer group, you need the following data.
No. Data
1 Type, name of the peer group, and the member peers
8.10.2 Creating an IBGP Peer Group
When BGP4+ has multiple IBGP peers, you can create an IBGP peer group to simplify the
management of routing policies. When creating an IBGP peer group, you do not need to specify
the AS number.
Context
Do as follows on the BGP4+ switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
group group-name [ internal ]
A peer group is created.
Step 4 Run:
ipv6-family [ unicast ]
The BGP IPv6 unicast address family view is displayed.
Step 5 Run:
peer group-name enable
The peer group is enabled.
Step 6 Run:
peer ipv6-address group group-name
The IPv6 peers are added to the peer group.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 8 BGP4+ Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
530
To Next Page
Loading...
Need help?
General
