Prerequisites
All BGP RR configurations are complete.
Procedure
l Run the display bgp vpnv4 { vpn-instance vpn-instance-name | all }peer [ [ ipv4-
address ] verbose ] command to check detailed information about BGP peers.
l Run the display bgp routing-table [ network [ { mask | mask-length } [ longer-
prefixes ] ] ] command to check information in a BGP routing table.
----End
7.10 Configuring a BGP Confederation
BGP confederations can be configured on a large BGP network to reduce the number of IBGP
connections and simplify routing policy management, increasing route advertisement efficiency.
Applicable Environment
A confederations can be used to reduce the number of IBGP connections in an AS. It divides an
AS into several sub-ASs. Full-mesh IBGP connections are established between devices in each
sub-AS, and full-mesh EBGP connections are established between devices in different sub-ASs,
Compared with RRs, confederations facilitate IGP extensions.
Pre-configuration Tasks
Before configuring a BGP confederation, complete the following tasks:
l Configuring link layer protocol parameters for interfaces to ensure that the link layer
protocol on the interfaces is Up
l Configuring Basic BGP Functions
Procedure
l Configure a BGP confederation.
Perform the following steps on a BGP device:
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
confederation id as-number
A confederation ID is set.
4. Run:
confederation peer-as as-number &<1-32>
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 7 BGP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
416
To Next Page
Loading...
Need help?
General
