Step 4 Run:
rip metricout { value | { acl-number | acl-name acl-name | ip-prefix ip-prefix-
name } value1 }
The metric added to an outgoing route is set.
NOTE
You can specify the value of the metric to be added to the RIP route that passes the filtering policy by
specifying value1 through an ACL or an IP prefix list. If a RIP route does not pass the filtering, its metric
is increased by 1.
----End
2.4.3 Configuring RIP Preference
When there are routes discovered by multiple routing protocols on the same Switch, you can set
RIP preferences to instruct the Switch to prefer certain RIP routes over others.
Context
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
Step 3 Run:
preference { preference | route-policy route-policy-name } *
The RIP preference is set.
By default, the RIP preference is 100.
----End
2.4.4 Setting the Maximum Number of Equal-Cost Routes
By setting the maximum number of equal-cost RIP routes, you can change the number of routes
for load balancing.
Context
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31
To Next Page
Loading...
Need help?
General
