EasyManuals Logo

Huawei S6700 Series Configuration Guide

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #313 background imageLoading...
Page #313 background image
The interface view is displayed.
3. Run:
isis peer-ip-ignore
IS-IS is configured not to check whether the IP addresses of received Hello packets
are on the same network segment.
----End
6.11.6 Checking the Configuration
After basic IPv6 IS-IS functions are configured, you can view information about IS-IS neighbors,
interfaces, and routes.
Prerequisites
The configurations of basic IPv6 IS-IS functions are complete.
Procedure
Step 1 Run the display isis name-table [ process-id | vpn-instance vpn-instance-name ] command to
check the mapping from the name of the local device to the system ID.
Step 2 Run the display isis peer [ verbose ] [ process-id | vpn-instance vpn-instance-name ] command
to check information about IS-IS neighbors.
Step 3 Run the display isis interface [ verbose ] [ process-id | vpn-instance vpn-instance-name ]
command to check information about IS-IS interfaces.
Step 4 Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6 [ verbose |
[ level-1 | level-2 ] | ipv6-address [ prefix-length ] ]
*
command to check information about IS-
IS routes.
----End
6.12 Configuring IPv6 IS-IS Route Selection
Configuring IS-IS route selection can achieve refined control over route selection.
6.12.1 Establishing the Configuration Task
Before configuring IPv6 IS-IS route selection, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the data required for the
configuration. This will help you complete the configuration task quickly and efficiently.
Applicable Environment
After basic IPv6 IS-IS functions are configured, IS-IS routes will be generated, enabling
communication between different nodes on a network.
If multiple routes are available, a route discovered by IS-IS may not the optimal route. This does
not meet network planning requirements nor facilitates traffic management. Therefore, configure
IPv6 IS-IS route selection to implement refined control over route selection.
To implement refined control over IPv6 IS-IS route selection, perform the following operations:
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
294

Table of Contents

Other manuals for Huawei S6700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S6700 Series and is the answer not in the manual?

Huawei S6700 Series Specifications

General IconGeneral
BrandHuawei
ModelS6700 Series
CategorySwitch
LanguageEnglish

Related product manuals