EasyManuals Logo

Huawei S6700 Series Configuration Guide

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #310 background imageLoading...
Page #310 background image
The interface is configured to automatically calculate its cost.
The configuration of the bandwidth reference value takes effect only when the cost type is
wide or wide-compatible. In this case, Cost of each interface = (Value of bandwidth-
reference/Interface bandwidth) x 10.
If the cost-style is narrow, narrow-compatible, or compatible, the cost of each interface is
based on costs listed in Table 6-2.
Table 6-2 Mapping between IS-IS interface costs and interface bandwidth
Cost Bandwidth Range
60
Interface bandwidth ≤ 10 Mbit/s
50
10 Mbit/s < interface bandwidth ≤ 100 Mbit/
s
40
100 Mbit/s < interface bandwidth ≤ 155 Mbit/
s
30
155 Mbit/s < interface bandwidth ≤ 622 Mbit/
s
20
622 Mbit/s < Interface bandwidth ≤ 2.5 Gbit/
s
10 Interface bandwidth > 2.5 Gbit/s
NOTE
To change the cost of a loopback interface, run the isis ipv6 cost command only in the loopback
interface view.
----End
6.11.5 (Optional) Configuring IPv6 IS-IS Attributes for Interfaces
on Different Types of Networks
Different IS-IS attributes can be configured for different types of network interfaces.
Context
The establishment modes of IS-IS neighbor relationships are different on a broadcast network
and on a P2P network. Different IS-IS attributes can be configured for interfaces on different
types of networks.
IS-IS is required to select a DIS on a broadcast network. Configure the DIS priorities of IS-IS
interfaces so that the interface with the highest priority will be selected as the DIS.
The network types of the IS-IS interfaces on both ends of a link must be the same; otherwise,
the IS-IS neighbor relationship cannot be established between the two interfaces. For example,
if the type of an interface on a peer device is P2P, you can configure the type of an interface on
the local device to P2P so that an IS-IS neighbor relationship can be established between the
two devices.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
291

Table of Contents

Other manuals for Huawei S6700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S6700 Series and is the answer not in the manual?

Huawei S6700 Series Specifications

General IconGeneral
BrandHuawei
ModelS6700 Series
CategorySwitch
LanguageEnglish

Related product manuals