Context
If a switch does not receive any Hello packet from its neighbor during a specified period, the
neighbor switch is considered invalid. The specified period is called the dead time of the neighbor
relationship. The dead time must be at least four times the Hello interval on an interface.
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 timer dead interval [ instance instance-id ]
The dead time of the neighbor relationship is specified.
----End
5.4.4 Configuring the Interval for Retransmitting LSAs to
Neighboring Switches
After a switch sends an LSA to its neighbor, the switch expects to receive an LSAck packet from
its neighbor. If the router does not receive an LSAck packet within the LSA retransmission
interval, it retransmits the LSA to the neighbor.
Context
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 timer retransmit interval [ instance instance-id ]
The interval for retransmitting LSAs to the adjacent routers is set.
The value of seconds must be greater than the time taken to transmit a packet between two
switches.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 5 OSPFv3 Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
193
To Next Page
Loading...
Need help?
General
