EasyManuals Logo

Huawei S6700 Series Configuration Guide

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #279 background imageLoading...
Page #279 background image
6.5 Configuring IPv4 IS-IS Route Selection
Configuring IS-IS route selection can achieve refined control over route selection.
6.5.1 Establishing the Configuration Task
Before configuring IPv4 IS-IS route selection, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the data required for the
configuration. This will help you complete the configuration task quickly and efficiently.
Applicable Environment
After basic IPv4 IS-IS functions are configured, IS-IS routes will be generated, enabling
communication between different nodes on a network.
If multiple routes are available, a route discovered by IS-IS may not the optimal route. This does
not meet network planning requirements nor facilitates traffic management. Therefore, configure
IPv4 IS-IS route selection to implement refined control over route selection.
To implement refined control over IPv4 IS-IS route selection, perform the following operations:
l Configuring the IPv4 IS-IS Interfaces.
NOTE
Changing the IS-IS cost for an interface can achieve the function of controlling route selection, but
requires routes on the interface to be recalculated and reconverged when a network topology changes,
especially on a large-scale network. In addition, the configuration result may not meet your
expectation.
Therefore, the configuration of changing IS-IS costs has best to be finished when configuring basic
IS-IS functions.
l Configure IPv4 IS-IS route leaking.
l Configure principles for selecting equal-cost IPv4 IS-IS routes.
l Filter IPv4 IS-IS routes.
l Configure an overload bit for an IPv4 IS-IS device.
Pre-configuration Tasks
Before configuring IPv4 IS-IS route selection, complete the following tasks:
l Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at
the network layer
l Configuring Basic IPv4 IS-IS Functions
Data Preparation
To configure IPv4 IS-IS route selection, you need the following data.
No.
Data
1 ACL for filtering routes, IP prefix list, or routing policy
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 6 IS-IS Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
260

Table of Contents

Other manuals for Huawei S6700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei S6700 Series and is the answer not in the manual?

Huawei S6700 Series Specifications

General IconGeneral
BrandHuawei
ModelS6700 Series
CategorySwitch
LanguageEnglish

Related product manuals