The system view is displayed.
Step 2 Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
Step 3 Run:
maximum load-balancing number
The maximum number of equal-cost routes is set.
----End
2.4.5 Checking the Configuration
After RIP route attributes are successfully set, you can view the current running status,
configuration, and routing information about RIP.
Prerequisites
The configurations for RIP route attributes are complete.
Procedure
l Run display rip [ process-id | vpn-instance vpn-instance-name ] command to check the
running status and configuration of RIP.
l Run display rip process-id database command to check all activated routes in the RIP
database.
l Run display rip process-id route command to check all the RIP routes that are learned
from other switchs.
----End
2.5 Controlling the Advertising of RIP Routing Information
To meet the requirements of complex networks, accurately controlling the advertising of RIP
routing information is essential.
2.5.1 Establishing the Configuration Task
RIP routing information can be advertised through default routes, Update packets, and imported
external routes.
Applicable Environment
To meet the requirements of a network, you need to control the advertising of RIP routing
information accurately. After performing the configuration procedures in this section, you can:
l Advertise default routes to neighbors.
l Suppress interfaces from sending RIP Update packets.
l Import external routes from various routing protocols and filter the routes to be advertised.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 2 RIP Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
32
To Next Page
Loading...
Need help?
General
