Context
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ripng [ process-id ]
The RIPng view is displayed.
Step 3 Run:
checkzero
The zero field check is configured for RIPng packets.
----End
3.7.6 Checking the Configuration
After the function of adjusting and optimizing the RIPng network performance is successfully
configured, you can view routing information, neighbor information, and interface information
of RIPng.
Prerequisites
The configurations of adjusting and optimizing the RIPng network performance are complete.
Procedure
l Run the display ripng [ process-id ] command to check the configuration of the RIPng
process.
l Run the display ripng process-id database [ verbose ] command to check all activated
routes in the RIPng database.
l Run the display ripng process-id interface [ interface-type interface-number ]
[ verbose ] command to check information about the RIPng interface.
l Run the display ripng process-id neighbor [ verbose ] command to check information
about RIPng neighbors.
l Run the display ripng process-id route command to check all the RIPng routes that are
learned from other switchs.
----End
3.8 Maintaining RIPng
This section describes how to clear statistics of a specified RIPng process.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
75
To Next Page
Loading...
Need help?
General
