The interface view is displayed.
Step 3 Run:
ripng summary-address ipv6-address prefix-length [ avoid-feedback ]
RIPng route summarization is configured.
----End
3.5.3 Configuring RIPng to Advertise the Default Routes
There are two methods of advertising RIPng default routes. You can configure a router to
advertise RIPng default routes according to the actual networking. Additionally, you can specify
the cost of the default routes to be advertised.
Context
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
ripng default-route { only | originate } [ cost cost ]
RIPng is configured to advertise a default route.
You can configure RIPng to advertise default routes as required:
l only: advertises only IPv6 default routes (::/0) and suppresses the advertising of other routes.
l originate: advertises IPv6 default routes (::/0) and does not affect the advertising of other
routes.
A RIPng default route is forcibly advertised by using an Update packet through a specified
interface, regardless of whether this route exists in the IPv6 routing table.
----End
3.5.4 Configuring the Default Cost for External Routes Imported by
RIPng
If RIPng imports routes from other routing protocols, but no metric is specified, you can set the
default metric for imported external routes.
Context
Do as follows on the RIPng switch:
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
68
To Next Page
Loading...
Need help?
General
