KE-2050/KE-2060, KE-2050R/2055R/KE-2060R Maintenance Manual
8-1
DANGER
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
[8] VCS
8-1. Replacing the CCD Camera Lens
(1) Detach the nylatch of the light unit cover to remove the flat plate V before and after the cover.
(2) Detach the cable clamp d on the rear and disconnect the power cable of the light unit.
Additionally, if the machine is equipped with the optional VCS, disconnect the piping of the
change-over air cylinder and the connector of the change-over sensor.
(3) Remove the light unit c set bolts (4 locations) to detach the light unit.
(4) When the light unit is detached, a camera will be exposed, so remove it.
Rev. 2.00
Cable clamp d
Flat plate V
Nylatch
Figure 8-1-1
SL6051292TN
M5 × 12 SEMS cap bolts c × 4
To Next Page
Loading...
Need help?
General
