8-S2
BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
FRONT LOADER
[3] LUBRICANTS
To prevent serious damage to hydraulic system, use only specified fluid or its equivalent.
• * KUBOTA SUPER UDT Fluid.................KUBOTA original transmission hydraulic fluid
W1010650
[4] MAINTENANCE CHECK LIST
To keep the machine working in good condition as well as to avoid any accident and trouble, carry out periodic
inspection and maintenance. Check the following points before use.
W1010764
[5] CHECK AND MAINTENANCE
• When checking and repairing, park the tractor on flat ground and apply the parking brake.
• When checking and repairing, lower the bucket and stop the engine.
(1) Check Points of Each Use or Daily
Checking Transmission Fluid Level
1. Check the oil level at the dipstick (1).
2. If the level is too low, add new oil to the prescribed level at the oil
inlet.
• If oil level is low, do not run engine.
W1010960
Checking Hydraulic Hoses
1. Checking all hydraulic hoses for cuts or wear.
2. If defects are found, replace them.
W1011064
Place Capacities Lubricants
Transmission Case
11.6 L
3.1 U.S.gals
2.6 lmp.gals
KUBOTA SUPER UDT Fluid *
Grease fitting Until grease overflows Moly Ep Type grease
Service Internal Check Points
Reference
Page
Daily (Each use) Check the transmission fluid level 8-S2
Check the hydraulic hoses 8-S2
Every 10 hours Grease all grease fitting 8-S3
Lubricate joints of control lever linkage 8-S3
(1) Dipstick A : Oil level is acceptable within this
range.
(1) Hydraulic Hose
(2) Cardboard
(3) Magnifying Glass
To Next Page
Loading...
Need help?
General
