G-41
BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
G GENERAL
9. TIRES
[1] TIRE PRESSURE
• Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper
equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended pressure shown in the operator’s manual.
• Do not use tires larger than specified.
• When you intend to mount different size of tires from equipped ones, consult your distributor about front
drive gear ratio for detail.
Excessive wear of tires may occur due to improper gear ratio.
Though the tire pressure is factory-set to the prescribed level, it naturally drops slowly in the course of time.
Thus, check it everyday and inflate as necessary.
• Maintain the maximum pressure in front tires, if using a front loader or when equipped with a full load of
front weights.
without
Loader
Tire sizes Inflation pressure
Rear
26 12.00 – 12 Turf
26 12.00 – 12 Bar
26 12.00 – 12 Ind.
140 kPa (1.4 kgf/cm
2
, 20 psi)
140 kPa (1.4 kgf/cm
2
, 20 psi)
140 kPa (1.4 kgf/cm
2
, 20 psi)
Front
18 8.50 – 10 Turf
18 8.50 – 10 Bar
18 8.50 – 10 Ind.
150 kPa (1.5 kgf/cm
2
, 22 psi)
150 kPa (1.5 kgf/cm
2
, 22 psi)
150 kPa (1.5 kgf/cm
2
, 22 psi)
with
Loader
Tire sizes Inflation pressure
Rear
26 12.00 – 12 Turf
26 12.00 – 12 Bar
26 12.00 – 12 Ind.
140 kPa (1.4 kgf/cm
2
, 20 psi)
140 kPa (1.4 kgf/cm
2
, 20 psi)
140 kPa (1.4 kgf/cm
2
, 20 psi)
Front
18 8.50 – 10 Turf
18 8.50 – 10 Bar
18 8.50 – 10 Ind.
180 kPa (1.8 kgf/cm
2
, 25.4 psi)
180 kPa (1.8 kgf/cm
2
, 25.4 psi)
180 kPa (1.8 kgf/cm
2
, 25.4 psi)