Lantronix SLC 8000 User Manual

9: USB/SD Card Port
SLC™ 8000 Advanced Console Manager User Guide 191
IP Settings
4. Click Apply.
Manage Files
To manage files, perform the following steps.
1. Click the Manage Files on the Storage Device link on the Devices > USB > Configure page.
Figure 9-5 Firmware and Configurations - Manage Files
Service The available connection services for this modem port (None, Telnet, SSH, or
TCP). Only one can be active at a time. The default is None.
Telnet Port Telnet Port Telnet session port number to use if you selected Telnet. Defaults:
 USB Port U1: 2049
 USB Port U2: 2050
 Range: 1025-65535
SSH Port The SSH session port number to use if you selected SSH.
Defaults:
 USB Port U1: 3049
 USB Port U2: 3050
 Range: 1025-65535
TCP Port The TCP (raw) session port number to use if you selected TCP.
Defaults:
 USB Port U1: 4049
 USB Port U2: 4050
 Range: 1025-65535
Authenticate
(checkbox)
If selected, the SLC unit requires user authentication before granting access to
the port. Authenticate is selected by default for Telnet Port and SSH Port, but
not for TCP Port.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm