Lantronix SLC 8000 User Manual

SLC™ 8000 Advanced Console Manager User Guide 66
6: Basic Parameters
This chapter explains how to set the following basic configuration settings for the SLC advanced
console manager using the SLC web interface or the CLI:
 Network parameters that determine how the SLC 8000 advanced console manager interacts
with the attached network
 Firewall and routing
 Date and time
Note: If you entered some of these settings using a Quick Setup procedure, you may
update them here.
Requirements
If you assign a different IP address from the current one, it must be within a valid range and unique
to your network. If a valid gateway address has not been assigned the IP address must be on the
same subnet as workstations connecting to the SLC 8000 over the network.
To configure the unit, you need the following information:
Eth1 IP address: ________ - ________ - ________ - ________
Subnet mask: ________ - ________ - ________ - ________
Eth2 IP address (optional): ________ - ________ - ________ - ________
Subnet mask (optional): ________ - ________ - ________ - ________
Gateway: ___________ - ___________ - ___________ - ___________
DNS: ___________ - ___________ - ___________ - ___________

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm