Lantronix SLC 8000 User Manual

4: Quick Setup
SLC™ 8000 Advanced Console Manager User Guide 56
- With a network connection, use an SSH client or Telnet program (if Telnet has been
enabled) to connect to xx.xx.xx.xx (the IP address in dot quad notation), and press
Enter. You should be at the login prompt.
2. Enter sysadmin as the user name and press Enter.
3. Enter PASS as the password and press Enter. The first time you log in, the Quick Setup script
runs automatically. Normally, the command prompt displays.
Figure 4-8 Beginning of Quick Setup Script
Welcome to the Lantronix SLC8000 Advanced Console Manager
Model Number: SLC8032
Quick Setup will now step you through configuring a few basic settings.
The current settings are shown in brackets ('[]').
You can accept the current setting for each question by pressing
<return>.
4. Enter the following information at the prompts:
Note: To accept a default or to skip an entry that is not required, press Enter.
CLI Quick Setup
Settings
Description
Config Eth1 Select one of the following:
 (1) obtain IP Address from DHCP: The unit will acquire the IP address, subnet
mask, hostname, and gateway from the DHCP server. (The DHCP server may or
may not provide the gateway and hostname, depending on its setup.) This is the
default setting.
 (2) obtain IP Address from BOOTP: Permits a network node to request
configuration information from a BOOTP "server" node.
 (3) static IP Address: Allows you to assign a static IP address manually. The IP
address is generally provided by the system administrator.
IP Address (if
specifying)
An IP address that is unique and valid on your network and in the same subnet as
your PC. There is no default.
If you selected DHCP or BOOTP, this prompt does not display.
Enter all IP addresses in dot-quad notation. Do not use leading zeros in the fields for
dot-quad numbers less than 100. For example, if your IP address is 172.19.201.28,
do not enter 028 for the last octet.
Note: Configurations with the same IP subnet on multiple interfaces (Ethernet or
PPP) are not currently supported.
Subnet Mask The subnet mask specifies the network segment on which the SLC 8000 advanced
console manager resides. There is no default. If you selected DHCP or BOOTP, this
prompt does not display.
Default Gateway IP address of the router for this network. There is no default.
Hostname
The default host name is
slcXXXX, where XXXX is the last 4 characters of the
hardware address of Ethernet Port 1. There is a 64-character limit (contiguous
characters, no spaces).
Note: The host name becomes the prompt in the command line interface.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm