Lantronix SLC 8000 User Manual

7: Services
SLC™ 8000 Advanced Console Manager User Guide 97
3. To save, click the Apply button.
SNMP, SSH, Telnet, and Logging Commands
The following CLI commands correspond to the web page entries described above.
To configure services (system logging, SSH and Telnet access, SSH and Telnet timeout,
SNMP agent, email (SMTP) server, and audit log):
set services <one or more services parameters>
Parameters
netlog <off|error|warning|info|debug> auditlog <enable|disable>
authlog <off|error|warning|info|debug> auditsize <1-500 Kbytes>
diaglog <off|error|warning|info|debug> clicommands <enable|disable>
servlog <off|error|warning|info|debug> includesyslog <enable|disable>
devlog <off|error|warning|info|debug> snmp <enable|disable>
genlog <off|error|warning|info|debug> v1v2 <enable|disable>
syslogserver1 <IP Address or Name> traps <enable|disable>
syslogserver2 <IP Address or Name> trapversion <1|2|3>
rpmlogsize <5-40 Kbytes> nms1 <IP Address or Name>
otherlogsize <5-400 Kbytes> nms2 <IP Address or Name>
telnet <enable|disable> alarmdelay <1-6000 Seconds>
timeouttelnet <disable|1-30 minutes> location <Physical Location>
telnetdatadir <netin|netout|both> contact <Admin Contact Info>
webtelnet <enable|disable> rocommunity <Read-Only
Community>
escapeseqtelnet <1-10 Chars> rwcommunity <Read-Write
Community>
outgoingtelnet <enable|disable> trapcommunity <Trap Community>
ssh <enable|disable> v3user <v3 RO User>
portssh <TCP Port> v3rwuser <v3 RW User>
v1ssh <enable|disable> v3trapuser <v3 Trap User>
timeoutssh <disable|1-30 minutes> v3security
<noauth|auth|authencrypt>
sshdatadir <netin|netout|both> v3auth <md5|sha>
dsakeys <enable|disable> v3encrypt <des|aes>
webssh <enable|disable> phonehome <enable|disable>
smtpserver <IP Address or Name> phoneip <IP Address>
smtpsender <Email Address> termbufsize <Number of Lines>
To set SNMP v3 read-only password or passphrase, or read-write password or passphrase:
set services v3password|v3phrase|v3rwpassword|v3rwphrase|v3trappassword
|v3trapphrase
Password/
Retype Password
Password for the user with authority to send v3 traps. The default is
SNMPTRAPPASS. Up to 20 characters.
Passphrase/
Retype
Passphrase
Passphrase associated with the password for a user with authority to send v3 traps. Up
to 20 characters. If this is not specified it will default to the v3 Trap Password.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm