Lantronix SLC 8000 User Manual

13: Maintenance
SLC™ 8000 Advanced Console Manager User Guide 296
Events
On this Maintenance > Events page, you can define what action you want to take for events that
may occur in the SLC unit.
1. Click the Maintenance tab and select the Events option. The following page displays:
Figure 13-13 Maintenance > Events
2. Enter the following:
Event Trigger From the drop-down list, select the type of incident that triggers an event. Currently,
the options are:
 Receive Trap
 Temperature Over/Under Limit (for Sensorsoft devices)
 Humidity Over/Under Limit (for Sensorsoft devices)
 Device Port Data Drop
 No Internal Modem Dial Tone
 Ping Host Fails
 RPM Load Over Threshold
Host to Ping When the trigger is set to Ping Host Fails, enter the hostname, IPv4 address or
IPv6 address of the host to ping. The host will be pinged every 2 minutes.
RPM When the trigger is set to RPM Load over Threshold, select the RPM that will be
monitored for a current that exceeds a defined threshold. The RPM needs to
support providing a current level as part of its status information. The RPM current
will be checked every 2 minutes.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm