Lantronix SLC 8000 User Manual

12: User Authentication
SLC™ 8000 Advanced Console Manager User Guide 221
Local and Remote User Settings
The system administrator can configure the SLC 8000 advanced console manager to use local
accounts and remote accounts to authenticate users.
1. Click the User Authentication tab and select the Local/Remote Users option. The following
page displays.
Figure 12-3 User Authentication > Local/Remote Users
The top of the page has entry fields for enabling local and remote users and for setting
password requirements. The bottom of the page displays a table listing and describing all local
and remote users.
To enable local and/or remote users:
1) Enter the following:
Enable Local Users Select to enable all local users except sysadmin. The sysadmin is always
available regardless of how you set the check box. Enabled by default.
Multiple Sysadmin
Web Logins
Select to allow the sysadmin to have multiple simultaneous logins to the web
interface. Disabled by default.
Sysadmin Access
Limited to Console
Port
Select to limit sysadmin logins to the Console Port only. Disabled by default.
Authenticate only
remote users who are
in the remote users list
Select the check box to authenticate users listed in the Remote Users list in the
lower part of the page. Disabled by default.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm